2024-08-23

Accelerator (Remove and Replace)

Code de correction 17551002 0.48 REMARQUE : À moins d’indications explicites contraires dans la procédure, le code de correction et le temps forfaitaire ci-dessus représentent tout le travail à être fait pour cette procédure, notamment les procédures connexes. N’appliquez pas plusieurs codes de correction à la fois, à moins qu’il vous soit explicitement indiqué de le faire. REMARQUE : Consultez Temps forfaitaires pour en apprendre plus à propos des temps forfaitaires et de leur création. REMARQUE : Consultez Protection individuelle pour vous assurer de porter l’équipement de protection individuelle adéquat lors vous effectuez la procédure ci-dessous. REMARQUE : Voir pour consulter les pratiques de travail sécuritaires et saines.

Retirer

  1. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Disconnect 12V/LV power. See 12V/LV Power (Disconnect and Connect).
  4. Remove the driver knee airbag. See .
  5. Remove the LH footwell duct. See #GUID-4B963839-927B-422B-B1BC-81666CE43923.
  6. Disconnect the electrical connector from the accelerator.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If the connector locking tab is red, pull the red locking tab away from the pedal housing.
  7. Remove the bolt that attaches the accelerator to the body.
  8. Slide the accelerator downwards, and then remove the accelerator from the vehicle.

Installer

  1. Slide the accelerator up, and then install the accelerator into the bracket.
  2. Install the bolt that attaches the accelerator to the body.
    7 Nm (5.2 lbs-ft)
  3. Connect the accelerator electrical connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    If the connector locking tab is red: push the red locking tab towards the pedal housing.
  4. Install the LH footwell duct. See #GUID-4B963839-927B-422B-B1BC-81666CE43923.
  5. Install the driver knee airbag. See .
  6. Reconnect 12V/LV power. See 12V/LV Power (Disconnect and Connect).
  7. Branchez un ordinateur portable doté du logiciel Boîte d’outils 3 au véhicule.
  8. Run the following Toolbox routines to confirm pedal operation:
    • TEST-SELF_PMR_X_CAN-COMMSvia Toolbox:(link)
  9. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  10. Install the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).