Removing and Installing Wheel Covers

If your Cybertruck is equipped with wheel covers, you must remove them to access the valve stem and the lug nuts.

To remove a wheel cover:

  1. Grasp the cover firmly with both hands.
  2. Pull the cover toward you to release the retaining clips.
    The wheel cover with an arrow pointing outwards away from the wheel
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the mounting ring is removed with the wheel cover.

To install a wheel cover:

  1. Separate the mounting ring from the wheel cover by pulling the platic ring from the inside of the wheel cover.
    The inside of the wheel cover with the mounting ring highlighted in blue
  2. Align the mounting ring with the spokes of the wheel. Firmly press the mounting ring into the wheel to secure it.
    The wheel with the mounting ring inserted
  3. Align the wheel cover with the design of the tire.
  4. Firmly press the center of the cover to secure it in place, then work your way out to firmly pressing the outer perimeter of each spoke. You may need to hold the opposite side of the cover until all spokes are secured.
  5. Firmly press the center of the cap with your hands (do not hit the cover with your hands) to ensure it is secured.
  6. As a final check, quickly pull each spoke to confirm it is secured in place.
The wheel cover with an arrow pointing inwards toward the wheel
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
To prevent the wheel cover from falling off, ensure that it is fully secured before driving.