Installing Cybertruck Projection Lights

This procedure and illustrations detail how to install the left front Projection Light. Instructions for the right side are mirrored.

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Do not close the door during installation. Closing the door may damage the window.
Informational PurposesAn informational icon, calling your attention
Note
Install the left (LH) Projection Light to the left front door panel, and the right (RH) projection light to the right front door panel.
  1. Open the left front door and fully lower the left front window. Carefully use a small screwdriver or pry tool to pry the existing puddle light out of the bottom of the left front door panel.
  2. Press down on the locking tab to disconnect the puddle light connector, then remove the light from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not pull the puddle light too far from the door panel, as the puddle light connector is still attached.
  3. Align the raised ribs on the light with the corresponding slot in the door panel.
  4. Connect the electrical wiring harness to the Cybertruck Projection Light.
    Informational PurposesAn informational icon, calling your attention
    Note
    Once connected correctly, the Cybertruck Projection Light will turn on and display the Cybertruck logo.
  5. Insert the Cybertruck Projection Light in the opening at the bottom of the door panel. Press upward firmly to ensure the Cybertruck Projection Light snaps securely into the door panel.
  6. Raise the left front window and close the left front door.
  7. Perform this procedure again on the right side of the vehicle to install the right Cybertruck Projection Light.