Appendix D: Configure Energy Metering

Powerwall 2 AC with Backup Gateway 2 Installation Manual
General Warnings and Information
Specifications
- Powerwall Specifications
- Backup Gateway 2 Specifications
Registering Powerwall
Site Requirements and Pre-Installation Guidance
Preparing for Installation
STEP 1: Plan the Installation Site
STEP 2: Mount Powerwall and the Backup Gateway
STEP 3: Configure the Backup Gateway for Wiring
- Remove Neutral-Ground Bonding Strap from Backup Gateway if Not Installed as Service Equipment
STEP 4: Make AC Power Connections
STEP 5: Make Communications Connections
- Connect Powerwall to the Backup Gateway
  - Panel Limit Feature
- Install Optional Remote Disable Switch
STEP 6: Install Energy Metering for the System
- About Energy Metering
- Site and Solar Metering for Backup Gateway 2
  - Install Tesla 100 A CTs
STEP 7: Complete the Installation
- Plan Internet Connection for the Backup Gateway 2
- Close the Wiring Compartments and Turn the System On
STEP 8: Perform Device Setup
Appendix A: Powerwall Mounting Details
Appendix B: Wiring Reference
Appendix C: System Wiring Diagrams
Appendix D: Configure Energy Metering
Appendix E: Installing a Neurio Energy Meter
Appendix F: Feature Notes
Appendix G: Installation Troubleshooting
Appendix H: Installing the Cold Weather Kit
Appendix I: Multi-Powerwall Installations
- Electrical Equipment Sizing and Overcurrent Protection
- Multi-Powerwall Installations with the Stack Kit
Appendix J: Inverter Settings
Appendix K: Revision Log