Determine True String VOC

True String VOC Test Overview

The following procedure closes the MCIs (also referred to as bypassing the MCIs) to check the Voc of the string, confirming that the string has been wired correctly.

Informational PurposesAn informational icon, calling your attention
Note
Perform this testing after wires have been pulled through but before they have been landed at the Powerwall 3.
Required Tools:
  • Klein ET600 Tester in 1000V mode
Figure 1. Klein ET600 Tester in 1000V Mode for True String VOC Test
  1. Safely shut the system down:
    1. Push the System Shutdown Switch if one is present, then turn the Enable switch OFF.
    2. Open the Powerwall 3 circuit breaker (turn OFF).
    3. Wait 30 seconds before proceeding with any work.
      Warning IconA warning icon, calling your attention to a possibly risky situation
      Warning
      Confirm Powerwall 3 is de-energized before proceeding. Confirm the breaker is open (OFF) and solar production is disabled in Tesla One.
  2. Plug the positive and negative meter tester leads into the meter. If you have a combination megger and multi-meter, make sure the tester leads are plugged into the ports for insulation testing.
  3. Set the tester to 1000V mode.
  4. Disconnect both (positive and negative) conductors to test a string. The conductors can be disconnected from the inverter (on the ground) or on the roof.
    Informational PurposesAn informational icon, calling your attention
    Note
    Paralleled strings must be tested independently. This must be done on the roof, and can be done by undoing Y-connectors or removing jumpers inside the combiner box.
    Informational PurposesAn informational icon, calling your attention
    Note
    For very short strings of two modules, test the short string together with a string that passes the test. Short strings may not be able to be tested by themselves.
  5. Connect the positive tester lead (red) to the positive conductor.
  6. Connect the negative tester lead (black) to the negative conductor.
    Figure 2. Testing Conductors on the Ground (at Inverter)
    Figure 3. Testing Conductors on the Roof
  7. Push the TEST button on the tester until the reading stabilizes.
  8. If any string does not display the expected string voltage (see planset), inspect the wiring on the roof to ensure it matches the design.
  9. If all wiring has been performed correctly, look for evidence of damage that may be causing the string to under perform:
    • Inspect where the wires exit conduit, as nicked wires may occur here
    • Check for wires pinched by mounting hardware
    • Look for evidence of damaged modules:
      • Microcracks
      • Signs of water intrusion
      • Module leads are bent at sharp angles