2026-07-20

Condenser (Remove and Replace)

Korrigeringskode 18201002 2.70 MERK: Hvis ikke noe annet er uttrykkelig oppgitt i prosedyren, gjenspeiler korrigeringskoden og FRT ovenfor, alt arbeidet som kreves for å gjennomføre denne prosedyren, inkludert de tilknyttede prosedyrene. Ikke stable korrigeringskoder med mindre du bli uttrykkelig bedt om det. MERK: Se Flat rate-tider for å lære mer om FRT-er og hvordan de lages. MERK: Se Personlig beskyttelse for å forsikre deg om at du bruker riktig PVU når du gjennomfører prosedyren nedenfor. MERK: Se for trygge og sunne arbeidspraksiser.

Informational PurposesAn informational icon, calling your attention
Note
This procedure requires the A/C Refrigerant (Recovery and Recharge) procedure to be performed. If not already automatically added to the Service Visit, add correction code 18200102 as a separate correction within the same activity to the Service Visit.

Fjerne

  1. Remove the cooling fan module. See Module - Cooling Fan (Remove and Install).
  2. Release the clips (x14) that attach the active grille shutter to the cooling fan module, and then remove the active grille shutter from the module.
  3. Remove the screws (x2) that attach the radiator to the cooling fan module.
    10 Nm (7.4 lbs-ft)
  4. Release the clip that attaches the radiator to the cooling fan module, and then remove the radiator from the cooling fan module.
  5. Release the clips (x2) that attach the condenser to the cooling fan module, and then remove the condenser from the cooling fan module.

Montere

Monteringsprosedyre er motsatt av demontering.