2026-06-25

Battery Flow Nut Replacement (Rear Crossmember)

校正代码： Pending 注意：除非本程序中有明确规定，否则上述校正代码涵盖执行本程序（包括关联碰撞维修程序以及服务程序）所需的所有碰撞维修和服务维修工作。除非明确要求，否则请勿堆叠碰撞维修校正代码。可能需要进行额外维修，具体视车辆损坏情况确定。

零件清单

数量 描述 图片/备注
1 NUT,REC,M8,[10],G0110,T02,BLUE (Square Nut)
1 HV BATTERY NUT STRIP (Nut Strip)
Informational PurposesAn informational icon, calling your attention
Note
If the original Nut Strip is not damaged, it can be reused.
2 拉钉
1 BUTYL FOIL PATCH 50x50x1mm Tesla part number 1045194-00-A.

如需订购零件，请参阅零件目录，输入需维修车辆 VIN，查找车辆正确零件（以及零件号）。或者，也可以在零件目录中搜索，查找车辆专用零件。

维修程序

  1. Cut an access window on the bottom of the crossmember.

    切割线

    参考线/点

    • A = 115 mm
    • B = 80 mm
    • C = 82 mm
    • D = 105 mm
  2. Remove the factory rivets in the repair area.
    或 原厂结构型铆钉
  3. Remove the Nut Strip through the access window.
    Informational PurposesAn informational icon, calling your attention
    Note
    If the original Nut Strip is not damaged, it can be reused.
  4. Remove the Battery Flow Nut from the Nut Strip.
  5. Install the Battery Flow Nut on the Nut Strip.
  6. Install the Nut Strip through the access window.
  7. Install fasteners through the crossmember and the Nut Strip.
    或 抽芯铆钉
  8. Apply an anti-corrosion coating to any bare metal.
  9. Install a butyl patch over the access window.
  10. 执行任何必要的维修后操作。