2026-07-08

Bumper Beam - Front (Remove and Replace)

Correction code 10011102 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.
  • 2026-06-24: Released new procedure.

Remove

  1. Disconnect 12V power. See Disconnect 12V Power.
  2. Remove the front fascia. See Fascia Assembly - Front (Remove and Install).
  3. Remove fastener from positive ground
    Informational PurposesAn informational icon, calling your attention
    Note
    1x bolt, 10mm , 6Nm
  4. Disconnect the front bumper accelerator sensor electrical connector
    Informational PurposesAn informational icon, calling your attention
    Note
    1x locking tab
  5. Release bumper foam
    Informational PurposesAn informational icon, calling your attention
    Note
    4x clips
  6. Remove front bumper accelerator sensor
    Informational PurposesAn informational icon, calling your attention
    Note
    10mm, 1x bolt, 10Nm
  7. Remove front bumper beam to the vehicle
    Informational PurposesAn informational icon, calling your attention
    Note
    4x nuts, 15mm, 60 Nm, 4x bolts, 15mm, 60N

Install

  1. Install front bumper beam to the vehicle
    Informational PurposesAn informational icon, calling your attention
    Note
    4x nuts, 15mm, 60 Nm, 4x bolts, 15mm, 60N
  2. Install front bumper accelerator sensor
    Informational PurposesAn informational icon, calling your attention
    Note
    10mm, 1x bolt, 10Nm
  3. Install bumper foam
    Informational PurposesAn informational icon, calling your attention
    Note
    4x clips
  4. Connect the front bumper accelerator sensor electrical connector
    Informational PurposesAn informational icon, calling your attention
    Note
    1x locking tab
  5. Install fastener to positive ground
    Informational PurposesAn informational icon, calling your attention
    Note
    1x bolt, 10mm , 6Nm
  6. Install the front fascia. See Fascia Assembly - Front (Remove and Install).
  7. Connect 12V power. See Disconnect 12V Power.