2026-08-10

Rear Panel Side Assembly

Correction code: 10101809302 10101809402 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair and Service repair work required to perform this procedure, including the linked Collision Repair procedures and linked Service procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Depending on the damage to the vehicle, additional repairs may be required.

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
This procedure can be completed without using a frame bench.

Parts List


Quantity	Description	Image / Notes
1	ASSEMBLY - REAR PANEL SIDE (Rear Panel Side Assembly)
4	Rivet, 4.8 mm
2	Countersunk Rivet, 4.8 mm Long
1	Structural Rivet, 6.5 mm Medium
2	Flow Form Rivet S18
1	Flow Form Rivet S38

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

Remove the Panel - Rear End (Remove and Replace).
Remove the Liftgate Seal (Remove and Replace).
Remove the Rear Bumper Fascia - Tail Lamp Bracket - LH (Remove and Replace).
RH Component only: Remove the Audio Amplifier (Remove and Install).
LH Component only: Remove the WheelHouse Insulator - Front - LH (Remove and Replace).
RH Component only: Remove the WheelHouse Insulator - Front - RH (Remove and Replace).
Remove the Cabin HVAC - Passenger Ducting and Vents - Air Extractor - LH (Remove and Install).
Remove the original component.
- or Factory SPRs
- or Factory Spot Welds
Remove the original component.
- or Factory SPRs
- or Factory Spot Welds
Prepare for installation.
Note
A red X indicates a location where a factory-installed fastener is not being replaced. Secure this location using structural adhesive only.
- or Rivets, 4.8 mm
- or Countersunk Rivets, 4.8 mm Long
- or Flow Form Rivets, S18
Prepare for installation.
Note
A red X indicates a location where a factory-installed fastener is not being replaced. Secure this location using structural adhesive only.
- or Rivets, 4.8 mm
- or Countersunk Rivets, 4.8 mm Long
- or Structural Rivets, 6.5 mm Medium
- or Flow Form Rivets, S38
- or Flow Form Rivets, S18
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
Perform any necessary post-repair operations.
Install the Cabin HVAC - Passenger Ducting and Vents - Air Extractor - LH (Remove and Install).
RH Component only: Install the WheelHouse Insulator - Front - RH (Remove and Replace).
LH Component only: Install the WheelHouse Insulator - Front - LH (Remove and Replace).
RH Component only: Install the Audio Amplifier (Remove and Install).
Install the Rear Bumper Fascia - Tail Lamp Bracket - LH (Remove and Replace).
Install the Liftgate Seal (Remove and Replace).
Install the Panel - Rear End (Remove and Replace).