Body Side Outer Rear Extension Lower
Correction code:
10101809802
10101810002
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | BSO REAR EXT LWR (Body Side Outer Rear Extension Lower) | |
| 8 |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the Wheel Liner - Rear - LH (Remove and Replace).
- Remove the Rear Wing Bracket - LH (Remove and Install).
- Remove the Cabin HVAC - Passenger Ducting and Vents - Air Extractor - LH (Remove and Install).
- LH Component only: Remove the WheelHouse Insulator - Rear - LH (Remove and Replace).
- RH Component only: Remove the WheelHouse Insulator - Rear - RH (Remove and Replace).
- RH Component only: Remove the Audio Amplifier (Remove and Install).
-
Remove the original component.
- or Factory Spot Welds
- or Factory SPRs
-
Prepare for installation.
NoteA red X indicates a location where a factory-installed fastener is not being replaced. Secure this location using structural adhesive only.
-
Prepare for installation.
- or Structural Bulb Rivets, 6.5 mm A = 19 mm B = 41 mm C = 10 mm D = 13 mm
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
- Perform any necessary post-repair operations.
- RH Component only: Install the Audio Amplifier (Remove and Install).
- RH Component only: Install the WheelHouse Insulator - Rear - RH (Remove and Replace).
- LH Component only: Install the WheelHouse Insulator - Rear - LH (Remove and Replace).
- Install the Cabin HVAC - Passenger Ducting and Vents - Air Extractor - LH (Remove and Install).
- Install the Rear Wing Bracket - LH (Remove and Install).
- Install the Wheel Liner - Rear - LH (Remove and Replace).