2026-05-12

Bumper Beam - Rear (Remove and Replace)

Correction code 10013102 1.14 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il tempo forfettario, o FRT, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

Torque Specifications

Tabella 1. Torque Specifications: Bumper Beam - Rear (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Nuts that attach the rear bumper beam to the body
60 Nm (44.2 lbs-ft)
  • 15 mm deep socket
 Reuse

Remove

  1. Remove the rear center bracket. See Bracket - Rear - Center (Remove and Replace).
  2. Remove the nuts that attach the rear bumper beam to the body, and then remove the rear bumper beam from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Recommend assistance when performing this step.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 15 mm deep socket
    • 6 in extension

Install

Informational PurposesAn informational icon, calling your attention
Note
A newer revision of the bumper beam has 3 holes for the studs on each side. If installing a newer revision, drill holes (x2) in the replacement part to accommodate for the extra studs. Do not drill holes if this repair is performed due to body damage and a new rear body panel has been installed. When installing a new rear body panel, the factory-installed bolts (x2) are not being replaced. See Rear Body Panel.
  1. Position the rear bumper beam on the body, and then install the nuts that attach the rear bumper beam to the body.
    60 Nm (44.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Recommend assistance when performing this step.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 15 mm deep socket
    • 6 in extension
  2. Install the rear center bracket. See Bracket - Rear - Center (Remove and Replace).