2026-05-12

Antenna - Bluetooth Passive Entry - Rear (Remove and Replace)

Correction code 17451802 0.78 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il tempo forfettario, o FRT, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

  • 2023-07-31: Moved software reinstall step to before Toolbox self test step.

Remove

  1. Remove the rear fascia. See Fascia - Rear (Remove and Install).
  2. Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
  3. Disconnect the electrical wiring harness connector from the rear Bluetooth passive entry module.
  4. Remove and discard the bolt and release the clip that attach the Bluetooth passive entry module to the body, and then remove the module from the bracket.
    Informational PurposesAn informational icon, calling your attention
    Note
    When releasing the module from the bracket, rotate the left side away from the bracket to release the tab.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • T30 socket
    • 2 in extension

Install

  1. Install the new bolt that attaches the Bluetooth passive entry module to the body.
    3.5 Nm (2.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • T30 socket
    • 2 in extension
  2. Connect the electrical wiring harness connector to the rear Bluetooth passive entry module.
  3. Connect 12V power. See 12V/LV Power (Disconnect and Connect).
  4. Reinstall the vehicle firmware. See .
  5. Perform the self-test routine in Toolbox:
    1. Connect a laptop with Toolbox 3.
    2. Click Actions/Autodiag, and then search for "Endpoint".
    3. Select TEST-SELF_VCSEC_X_ENDPOINT-COMMvia Toolbox:(link), and then click Run and allow routine to complete.
      Informational PurposesAn informational icon, calling your attention
      Note
      Once complete, click the X on the window to close it.
  6. Disconnect the laptop from the vehicle.
  7. Install the rear fascia. See Fascia - Rear (Remove and Install).