2026-05-12

Handle - Exterior Release - Door - Rear - LH (Remove and Replace)

Correction code 11452002 0.60 NOTA: Salvo explicitamente indicado em contrário no procedimento, o código de correção acima e o FRT refletem todo o trabalho necessário para a realização deste procedimento, incluindo os procedimentos associados. Não acumule códigos de correção, salvo se explicitamente instruído. NOTA: Consulte Tempos de taxa fixa para saber mais sobre FRT e sobre a respetiva criação. NOTA: Consulte Proteção pessoal para garantir que utiliza o EPI adequado durante a realização do procedimento abaixo. NOTA: Consulte para conhecer as práticas seguras e saudáveis de trabalho.

  • 2026-01-22: Updated the nuts secuing the handle to consumable parts and added the nut part number.
Warning IconA warning icon, calling your attention to a possibly risky situation
Aviso
The side impact airbag deployment depends on the front door sensor's ability to detect a side impact from air pressure. Make sure that there are no uncovered holes in the front door shells. Additionally, always reinstall plugs or tape when servicing or inspecting the front doors and their components.

Remove

  1. Remove the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Install).
  2. Remove the rear LH door glass. See Glass - Door - LH - Rear (Remove and Replace).
  3. Remove the LH rear window motor/regulator assembly. See Window Regulator - Rear - LH (Remove and Replace).
  4. Disconnect the electrical connector from the LH rear door exterior release handle.
  5. Remove the plugs (x2) that covers access to the LH rear door exterior release handle nuts.
  6. Remove and discard the nuts that attach the LH rear door exterior release handle to the door, and then remove the handle from the door.
    7 Nm (5.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    There are 2 versions of these nuts. Replace if the nuts are nyloc nuts. Reuse if the nuts are not.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket

Install

Installation procedure is the reverse of removal, except for the following:

  • Install new nuts to secure the handle to the door.
  • When a new handle is installed, or the removed handle is installed onto a new door, perform an adjustment of the handle.