2026-05-12

Skid Plate - HV Battery - Rear (Remove and Replace)

Correction code 16102202 0.48 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il tempo forfettario, o FRT, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

  • 2025-08-19: Updated torque figures and added Install section.

Torque Specifications

Tabella 1. Torque Specifications: Skid Plate - HV Battery - Rear (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the rear skid plate to the lower HV battery
13 Nm (9.6 lbs-ft)
  • External Torx Plus EP10
Reuse
Nut that attaches the rear skid plate to the upper HV battery
13 Nm (9.6 lbs-ft)
  • 10 mm socket
Reuse
Upper bolts that attach the rear skid plate to the HV battery
35 Nm (25.8 lbs-ft)
  • 13 mm socket
Reuse

Remove

  1. Remove the mid aero shield. See Panel - Aero Shield - Rear (Remove and Replace).
  2. Release the clips (x2) that attach the coolant hose to the LH shear plate.
  3. Release the clips that attach the hoses to the rear HV battery skid plate
  4. Remove the lower bolts that attach the skid plate to the HV battery.
  5. Remove the upper nuts that attach the skid plate to the HV battery.
  6. Remove the upper bolts that attach the skid plate to the HV battery, and then remove the skid plate from the HV battery.

Install

  1. Position the rear skid plate, and then install the upper bolts that attach the skid plate to the HV battery. Torque the bolts at a later stage.
  2. Install the lower bolts that attach the skid plate to the HV battery.
    13 Nm (9.6 lbs-ft)
  3. Install the upper nuts that attach the skid plate to the HV battery. Torque at a later step.
  4. Torque the upper bolts that attach the rear skid plate to the HV battery.
    35 Nm (25.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Some vehicles are equipped with self-tapping bolts from the factory. If the vehicle is equipped with a bolt with a hexagonal indentation on the bolt head (1637725-00-A), the torque value is 64 Nm.
  5. Torque the upper nut that attaches the rear skid plate to the HV battery.
    13 Nm (9.6 lbs-ft)
  6. Install the clips that attach the hoses to the rear HV battery skid plate
  7. Install the clips (x2) that attach the coolant hose to the LH shear plate.
  8. Install the mid aero shield. See Panel - Aero Shield - Rear (Remove and Replace).