2026-05-12

Bracket - 12V Battery (Dual Motor) (Remove and Replace)

Correction code 170140121.56 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il tempo forfettario, o FRT, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

Remove

  1. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Remove the cabin intake duct. See Duct - Upper - Cabin Intake (Remove and Replace).
  4. Remove the underhood storage unit. See #GUID-4FBD5199-27DF-4D9D-A193-1901CE127862.
  5. Remove the LH and RH wiper arms. See #GUID-40F2AE79-B55A-4796-B733-9622D9A5F73B.
  6. Remove the LH and RH shock tower covers. See Cover - Shock Tower - LH (Remove and Replace).
  7. Remove the cowl screen panel. See Panel - Cowl Screen (Remove and Replace).
  8. Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
  9. Remove the 12V auxiliary battery. See #GUID-A457202A-D5B8-4DAD-A374-C91A41A7B4F5.
  10. Remove the front body controller module. See Module - Body Controller - Front (Dual Motor) (Non-Heat Pump) (Remove and Replace).
  11. Release the clips that attach the coolant hoses and electrical harnesses to the 12V battery beam.
  12. Remove the bolts that attach the 12V battery beam to the vehicle.
    9 Nm (6.6 lbs-ft)
  13. Remove the 12V battery bracket and 12V battery beam from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Carefully slide the beam toward the RH side of the vehicle, and then lift the LH side of the beam to remove the assembly.
  14. Remove the bolts that attach the 12V battery beam to the 12V battery bracket, and then set the beam aside.
    9 Nm (6.6 lbs-ft)

Install

Installation procedure is the reverse of removal, except for the following:

  • Sostituire tutti i dadi Nyloc.
  • Sostituire tutti i bulloni svasati.