2026-05-12

Cover - Footwell - Driver (Remove and Replace)

Correction code 14055302 0.12 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il tempo forfettario, o FRT, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

Torque Specifications

Tabella 1. Torque Specifications: Cover - Footwell - Driver (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screw that attaches the driver footwell cover to the vehicle
2.5 Nm (1.8 lbs-ft)
  • Torx T20 socket
  • ¼ in std ratchet
  • ¼ in torque wrench (installation only)
  • 4 in extension
Reuse

Remove

  1. Release the clips and remove the screw that attach the driver footwell cover to the vehicle.
    2.5 Nm (1.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
    • ¼ in std ratchet
    • ¼ in torque wrench (installation only)
    • 4 in extension
    Figure 1. Left-Hand Drive (LHD)
    Figure 2. Right-Hand Drive (RHD)
  2. Disconnect the electrical connector from the puddle light, and then disconnect the diagnostic cable from the driver footwell cover.
    Figure 3. LHD shown, RHD similar
  3. APAC vehicles only: Disconnect the OBD-II connector from the driver footwell cover.
  4. Release the tabs that attach the driver footwell cover to the vehicle, and then remove the footwell cover from the vehicle.
    Figure 4. LHD
    Figure 5. RHD
    Figure 6. LHD
    Figure 7. RHD

Install

  1. Reconnect the diagnostic cable to the driver footwell cover, and then reconnect the electrical connector to the puddle light.
    Figure 8. LHD shown, RHD similar
  2. APAC vehicles only: Reconnect the OBD-II connector to the driver footwell cover.
  3. Position the footwell cover for installation by securing the front tabs to the driver knee air bag assembly, and then install the clips and the screw that attach the driver footwell cover to the vehicle.
    2.5 Nm (1.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
    • ¼ in std ratchet
    • ¼ in torque wrench (installation only)
    • 4 in extension
    Figure 9. LHD
    Figure 10. RHD