2026-05-12

Brightwork - Upper - LH (Remove and Replace)

Correction code 12200302 0.36 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il tempo forfettario, o FRT, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

Torque Specifications

Tabella 1. Torque Specifications: Brightwork - Upper - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws that attach the brightwork to the body
1 Nm (.7 lbs-ft)
  • Torx T20 socket
 Reuse
Grommets Replace 1106827-00-C

Remove

  1. Open the LH doors.
  2. Pull down to release the front and rear primary body seals from the LH upper brightwork.
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to release the seals from the top of the B-pillar applique.
  3. Remove the push rivet and the screws (x10) that attach the LH upper brightwork to the body, and then carefully remove the brightwork from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Work from the front to the rear.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Use an assistant to help remove the brightwork from the rear quarter glass, so as to minimize damage to the paint and trim.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  4. Remove and discard the grommets (x10) from the body.

Install

  1. Wipe where the grommets will install with an IPA wipe.
  2. Install new grommets (x10) into the body where the LH upper brightwork will install.
    Informational PurposesAn informational icon, calling your attention
    Note
    The number of grommets (1106827-00-C ) on newer vehicles may vary.
  3. Press the seals into the body at the B-pillar corners.
  4. With assistance, carefully install the LH upper brightwork into the rear quarter glass.
  5. Install the LH upper brightwork to the body, and then install the screws (x10) and push rivet that attach the brightwork to the body.
    1 Nm (.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
    Informational PurposesAn informational icon, calling your attention
    Note
    Work from the rear to the front.
  6. Press up to fasten the rear and front primary body seals onto the LH upper brightwork.
    Informational PurposesAn informational icon, calling your attention
    Note
    Work from the rear corner of each seal forward, and make sure that the seal fully engages the brightwork. When installed correctly, the seal edge is not visible.
  7. Work each seal around the opening so as to evenly distribute it.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure to push the seal into each corner.
  8. Close the LH doors.