2026-05-12

Sensor - Impact Accelerometer - C-Pillar - LH (Remove and Replace)

Correction code 20200702 0.24 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il tempo forfettario, o FRT, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

Warning IconA warning icon, calling your attention to a possibly risky situation
Avvertenza
Assicurarsi che l'alimentazione a 12 V/bassa tensione sia stata scollegata per almeno 1 minuto prima di scollegare il cablaggio elettrico dai componenti del sistema di ritenuta supplementare (SRS) come il modulo di controllo ritenuta, sensori, airbag ecc. Scollegare la batteria a 12V/bassa tensione e il circuito di primo soccorso. La mancata osservanza di queste precauzioni può causare comportamenti inattesi del sistema di sicurezza. Per ulteriori informazioni sulle precauzioni per il sistema SRS, vedere .

Remove

  1. Open all doors.
  2. Lower all windows.
  3. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  4. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  5. Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
  6. Remove the LH 2nd row seat side bolster. See Bolster - Side - Seat - 2nd Row - LH (Remove and Replace).
  7. Remove the LH rear sill panel trim. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  8. Remove the bolt that attaches the charge port harness bracket to the body, and then move the charge port harness away from the C-pillar.
    10 Nm (7.4 lbs-ft)
  9. Disconnect the electrical harness from the airbag sensor connector.
  10. Remove the bolt that attaches the airbag sensor to the C-pillar, and then remove the sensor from the vehicle.
    8 Nm (5.9 lbs-ft)

Install

Installation procedure is the reverse of removal.