2026-05-12

Valance - Front Fascia (Remove and Replace)

Correction code 10012202 0.36 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il tempo forfettario, o FRT, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

Remove

  1. Remove the front aero shield panel. See Panel - Aero Shield - Front (Remove and Replace).
  2. Release the clips (x2) that attach the valance to the stabilizer bar brackets.
  3. Remove the push clips (x4) that attach the LH and RH sides of the valance to the wheel liners.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove the outer clips as necessary to allow for easier access to the nuts behind the wheel liner.
  4. Remove the nuts (x2) at the LH and RH corners of the valance.
    Informational PurposesAn informational icon, calling your attention
    Note
    The nuts are accessed from behind the front of the wheel liners.
  5. Remove the push clips (x10) that attach the valance to the front fascia, and then remove the valance from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove clips from the center first and work outward.

Install

Installation procedure is the reverse of removal.

  1. Install the valance to the front fascia, and install the push clips (x10) that attach the valance to the fascia.
    Informational PurposesAn informational icon, calling your attention
    Note
    Fasten the clips at the far left and far right first and work inward.
  2. Install the nuts (x2) at the LH and RH corners of the valance.
    3 Nm (2.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    The nuts are accessed from behind the front of the wheel liners.
  3. Install the push clips (x4) that attach the LH and RH sides of the valance to the wheel liners.
    Informational PurposesAn informational icon, calling your attention
    Note
    Install the outer clips if removed earlier.
  4. Fasten the clips (x2) that attach the valance to the stabilizer bar brackets.
  5. Install the front aero shield panel. See Panel - Aero Shield - Front (Remove and Replace).