2026-05-27

Panel - Aero Shield - Front (Remove and Replace)

Correction code 12030102 0.18 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il tempo forfettario, o FRT, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

  • 2026-05-27: Updated the torque values of the nuts (x2) securing the front aero shield from 5.5 Nm to 8 Nm.

Torque Specifications

Table 1. Torque Specifications: Panel - Aero Shield - Front (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Aero shield panel to body nuts
8 Nm (5.9 lbs-ft)
  • 15 mm socket
 Reuse
Aero shield panel to body bolts
5 Nm (3.7 lbs-ft)
  • 10 mm socket
 Reuse

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  2. Remove the bolts (x9) that attach the front aero shield panel to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  3. Remove the nuts (x2) that attach the front aero shield panel to the vehicle, and then remove the panel from the vehicle
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 15 mm socket

Replace

  1. Apply a thin bead of Loctite 222 to the threads of the bolts (x9) that attach the front aero shield panel to the vehicle.
  2. Install the front aero shield panel to the underside of the vehicle, and then hand-tighten the nuts (x2) to temporarily hold the panel in place.
  3. Hand-tighten the bolts (x9) that attach the front aero shield panel to the vehicle.
  4. Torque the nuts (x2) and bolts (x9) to the proper specification.
    8 Nm (5.9 lbs-ft)
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 15 mm socket and 10 mm socket
    • ¼ in std ratchet
    • ¼ in torque wrench (installation only)
    • 4 in extension
  5. Lower the vehicle. See Raise Vehicle - 2 Post Lift.