2026-05-12

Brake Lines - LH Sill (Remove and Replace)

Correction code 33035102 4.68 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il tempo forfettario, o FRT, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

  • 2025-05-09: Updated the torque spec for the brake line tube nuts to 16 Nm.
Apparecchiatura:
  • 1079041-00-A Flare nut crowfoot set

Remove

  1. Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION

    Il liquido dei freni scioglie la vernice. Tenere a portata di mano dei panni puliti e abbondante acqua per sciacquare il liquido dei freni qualora si rovesciasse sulle superfici verniciate.

    Informational PurposesAn informational icon, calling your attention
    Note

    Dispose of used brake fluid in a manner consistent with local environmental codes.

  2. Remove the LH and RH lower rocker panel covers. See Cover - Rocker Panel - Lower - LH (Remove and Replace).
  3. Remove the HV battery. See HV Battery (RWD) (Remove and Install).
  4. Remove the LH front wheel arch liner. See Wheel Arch Liner - Front - LH (Remove and Replace).
  5. Remove the LH rear wheel arch liner. See Wheel Arch Liner - Rear - LH (Remove and Replace).
  6. Position the oil drain under the front brake line junction block.
  7. Remove the brake line tube nuts from the junction block. Allow the fluid to drain. Use a crowfoot extension to torque the nuts for installation.
    16 Nm (11.8 lbs-ft)
  8. Position the oil drain under the rear brake line junction block.
  9. Remove the brake line tube nuts from the junction block. Allow the fluid to drain. Use a crowfoot extension to torque the nuts for installation.
    16 Nm (11.8 lbs-ft)
  10. Remove the nut that attaches the rear junction block to the body, and separate the block from the body.
    7 Nm (5.2 lbs-ft)
  11. Release the clips that attach the brake lines to the body.
  12. Remove the brake lines from the vehicle.

Install

Installation procedure is the reverse of removal, except for the following:

  • Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION

    Sostituire tutti i dadi Nyloc.

    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning

    Non lavorare al di sotto di un veicolo che non sia correttamente sostenuto.

  • Bleed the brake lines for the rear calipers. See Brake Fluid Bleed - One Caliper.