2026-05-12

Seal - Secondary - Rear Door - LH (Remove and Replace)

Correction code 11705402 0.42 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il tempo forfettario, o FRT, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

  • 2023-08-30: Added a note to discard the old seal.

Remove

  1. Open the LH rear door.
  2. Release the LH rear glass run seal clips (x4) to fully access the LH rear door secondary seal.
  3. Use narrow-width tape to carefully mark the location of the secondary seal around the door.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Make sure that the edge of the tape accurately follows the edge of the seal.
  4. Release the ends of the door secondary seal from the ends of the inner belt seal.
  5. Slowly peel the length of the secondary seal from the perimeter of the rear door.
    Informational PurposesAn informational icon, calling your attention
    Note
    Discard the seal as it can not be reused.
  6. Clean any remaining adhesive or residue from the rear door.
    Informational PurposesAn informational icon, calling your attention
    Note
    If needed, carefully use the following tools to clean adhesive or residue:
    • 1071510-00-AWHEEL, STRIPE OFF
    • 1076972-00-A4 Piece Non-Marring Scraper Set
    • 2151853-00-A3M PN38180 Glue Cleaner_230G
    • 2150371-00-AIPA Wipers

Install

  1. Use IPA wipes to clean the LH rear door secondary seal installation path.
    Informational PurposesAn informational icon, calling your attention
    Note
    Allow 1 minute of dry time.
  2. Peel a short section of seal backing and insert the end of the seal into the rear of the inner belt seal.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure that the open edge of the seal is facing the inside of the door.
    Figure 1. Face open edge inward
  3. Peel the seal backing and carefully position the edge of the seal to the edge of the marking tape while working around the rear door.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not stretch the seal as it is applied to the door.
  4. Insert the end of the seal into the front of the inner belt seal.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the drain holes on the seal are at the bottom of the door.
  5. Use a seam roller to attach the seal to the rear door.
  6. Remove the marking tape from the rear door.
  7. Install the LH rear glass run seal clips (x4) to fully access the LH rear door secondary seal.