2026-05-12

Ankle Catcher (Remove and Replace)

Correction code 10011202 0.84 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il tempo forfettario, o FRT, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

Warning IconA warning icon, calling your attention to a possibly risky situation
Avvertenza
The corners of the ankle catcher are very sharp and might cause personal injury. When performing this procedure, make sure wearing proper PPE and pay attention to the sharp edges.

Remove

  1. Remove the front fascia. See Fascia - Front (Remove and Install).
  2. Remove the bolts that attach the bottom of the cooling fan module to the ankle catcher.
    Informational PurposesAn informational icon, calling your attention
    Note
    Lift the condenser fan module up to ease removal of the bolts.
  3. Loosen but do not remove the bolts that attach the upper section of the front end carrier to the body.
  4. Remove the bolts that attach the front end carrier to the crash cans.
  5. Move the front end carrier forward, slide the ankle catcher off the front end carrier locating posts, and then remove the ankle catcher from the vehicle.

Install

  1. Position the ankle carrier onto the front end carrier locating posts, and then slide the ankle catcher into place.
  2. Hand-tighten the bolts that attach the front end carrier to the crash cans.
  3. Torque the bolts that attach the front end carrier to the crash cans.
    16 Nm (11.8 lbs-ft)
  4. Tighten the bolts that attach the upper section of the front end carrier to the body.
    16 Nm (11.8 lbs-ft)
  5. Install the bolts that attach the bottom of the cooling fan module to the ankle catcher.
    10 Nm (7.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Lift the condenser fan module up to ease installation of the bolts.
  6. Install the front fascia. See Fascia - Front (Remove and Install).