Sill Plate - Front - LH (Remove and Replace)
Correction code
12051102
0.12
NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il tempo forfettario, o FRT, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo.
NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati.
NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.
Apparecchiatura:
- 1049517-00-A Seam Roller, Silicone, 5"
Remove
- Open the LH front door.
- Use IPA wipes to clean around the sill plate.
-
Apply masking tape around the perimeter of the sill plate to mark the installation positioning.
NotePlace the tape as closely around the sill plate as possible.
- Use a plastic trim tool to carefully pry up and bend the sill plate.
-
While using pliers to pull up on the sill plate, use a retractable blade to cut through the adhesive.
WarningTo reduce the risk of personal injury, wear cut-resistant gloves while performing this operation.CAUTIONBe careful not to damage the vehicle trim or body.
- Use IPA wipes to clean off any remaining adhesive.
Install
- Remove the adhesive backing from the new sill plate.
- Using the masking tape as a guide, carefully place the new sill plate into place and press down on it to adhere it to the vehicle.
-
Use a seam roller to fully wet out the adhesive.
- Remove the protective film from the sill plate.
- Remove the masking tape from the door sill.
- Close the LH front door.