2026-05-12

Trunk (Remove and Install)

Correction code 10107001 0.54 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il tempo forfettario, o FRT, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

Remove

  1. Remove the trunk lid trim. See #GUID-41EDADB7-1CC1-463E-A7A3-731AA88FEBDD.
  2. Disconnect the LH and RH rear fog/reverse light electrical connectors.
  3. Disconnect the rear facing camera electrical connector.
  4. Disconnect the trunk exterior release switch electrical connector.
  5. Disconnect the LH and RH license plate light electrical connectors.
    Figure 1. LH shown, RH similar
  6. Disconnect the trunk latch electrical connector.
  7. Remove and discard the bolts (x2) that attach the trunk harness ground straps to the trunk lid.
  8. Release the clips that attach the trunk harness to the trunk lid.
  9. Push the trunk harness through the trunk bulkhead and out of the trunk lid.
  10. Use a dry erase marker to mark the position of the trunk hinges on the trunk lid.
  11. Remove the bolts that attach the hinges to the trunk lid.
    Figure 2. RH shown, LH similar
  12. With an assistant, remove the lid from the vehicle, and then place it on a padded surface.

Install

Informational PurposesAn informational icon, calling your attention
TIp
For instructions on how to align the trunk, refer to .
  1. With an assistant, position and align the trunk lid to the trunk hinges, and then hand-tighten the bolts that attach the hinges to the trunk lid.
  2. Push the trunk harness through the trunk bulkhead.
  3. Install the clips that attach the trunk harness to the trunk lid.
  4. Install new bolts (x2) to attach the trunk harness ground straps to the trunk lid.
    8 Nm (5.9 lbs-ft)
  5. Connect the trunk latch electrical connector.
  6. Connect the LH and RH license plate light electrical connectors.
    Figure 3. LH shown, RH similar
  7. Connect the trunk exterior release switch electrical connector.
  8. Connect the rear facing camera electrical connector.
  9. Connect the LH and RH rear fog/reverse light electrical connectors.
  10. With an assistant, perform the gap and flush measurement of the trunk assembly.
  11. Tighten the bolts that attach the hinges to the trunk lid.
    24 Nm (17.7 lbs-ft)
    Figure 4. RH shown, LH similar
  12. Tighten the bolts that attach the trunk latch to the trunk lid.
    8 Nm (5.9 lbs-ft)
  13. Install the trunk lid trim. See #GUID-41EDADB7-1CC1-463E-A7A3-731AA88FEBDD.
  14. Clean the marks of the dry erase marker from the hinges.