2026-05-12

Radiator (Heat Pump) (Remove and Replace)

Correction code 18301022 1.26 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il tempo forfettario, o FRT, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

  • 2024-08-22: Updated linked to procedure to Cooling Fan Module to correct missing steps.

Remove

  1. Enable Service Mode through the touchscreen. See .
  2. Access the thermal system routines on the touchscreen: Touch Quick Controls > Service Mode > Diagnostics > Thermal.
    Informational PurposesAn informational icon, calling your attention
    Nota
    Authorize routines by holding the turn signal stalk full up (right hand turn) while applying brake with the key in the vehicle.
  3. Touch Start Thermal Fill Drain (Coolant Only) on the touchscreen.
    Informational PurposesAn informational icon, calling your attention
    Nota
    Touch the X at the top left of window to close once completed.
    Informational PurposesAn informational icon, calling your attention
    Nota
    Verify the indicator displays green and the vehicle is ready for the coolant fill/drain.
    Informational PurposesAn informational icon, calling your attention
    Nota
    Thermal "Fill Drain" routine has a 5 hour time limit. After 5 hours, the routine must be performed again.
  4. Remove the cooling fan module assembly. See .
  5. Remove the active grille shutter. See .
  6. Release the locking tabs that attach the radiator to the cooling fan and shroud assembly, and then remove the radiator from the fan and shroud assembly.
  7. Remove the stone guard. See .
    Informational PurposesAn informational icon, calling your attention
    Nota
    Perform this step only if the following conditions are met:
    • the old radiator is equipped with a stone guard.
    • the new radiator does not include a stone guard.

Install

Installation procedure is the reverse of removal, except for the following:
  1. If removed, install the stone guard. See .
  2. Install the radiator to the cooling fan and shroud assembly, and then fasten the locking tabs that attach the radiator to the fan and shroud assembly.
  3. Install the active grille shutter. See .
  4. Install the cooling fan module assembly. See .