Garnish - Trunk (Remove and Replace)
Correction code
15111102
0.06
NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il tempo forfettario, o FRT, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo.
NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati.
NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.
Remove
- Open the trunk.
-
Release the push clips (x2) that attach the ends of the trunk garnish to the body.
Figure 1. LH shown, RH similar -
Release the tabs that attach the trunk garnish to the body, and then remove the trunk garnish from the vehicle.
NoteIf the part removed has less tabs than shown in the illustration then the new part must be reworked to remove the extra tabs.
Retrofit
- If the trunk garnish removed has less tabs than the replacement part, then the replacement part must be reworked to remove the extra tabs. To account for the extra repair time required, use correction code 15111107 instead of 15111102.
-
Use a diagonal cutter or retractable blade knife to remove only the red
tabs shown.
CAUTIONUse eye protection, cut-resistant gloves, and proper PPE when performing the rework.
-
Make sure the reworked part matches the picture.
Install
-
Install the trunk garnish onto the body, and fasten the tabs that attach
the trunk garnish to the body.
NotaMake sure the trunk garnish is firmly attached to the body.
-
Fasten the push clips (x2) that attach the ends of the trunk garnish to the
body.
Figura 2. LH shown, RH similar - Close the trunk.