2026-05-12

Seal - Body - Side - Rear - Primary - LH (Remove and Replace)

Correction code 11700502 0.18 NOTA: Salvo diversa ed esplicita indicazione nella procedura, il codice modifica e il tempo forfettario, o FRT, riflettono tutto il lavoro richiesto per l'esecuzione di questa procedura, incluse le procedure collegate. Non cumulare i codici modifica a meno che non venga detto esplicitamente di farlo. NOTA: Consultare la Tempistica tariffe fisse per saperne di più sui tempi forfettari e su come essi vengono creati. NOTA: Consultare Protezione personale per assicurarsi di indossare i DPI adatti quando si esegue la procedura descritta di seguito. NOTA: Vedere per le pratiche di lavoro in sicurezza.

  • 2023-11-09: Added a note to the clip-fastening step.
Apparecchiatura:
  • 1143801-00-A - LED UNDERHOOD LIGHT

Remove

  1. Remove the LH B-pillar applique. See #GUID-23770827-D613-4A23-AF05-BE4B00E01701.
  2. Release the clips (x3) that attach the rear LH primary body seal to the mid B-pillar, the upper B-pillar, and the mid C-pillar.
  3. Pull on the seal to remove it from the body.

Install

  1. Loosely install the rear LH primary body seal to the body.
  2. If the vehicle has markings on the B-pillar, skip the next step and proceed with alignment and installation.
  3. Apply tape on the B-pillar and mark a line on the tape 8 mm (0.3 in) above and parallel to the B-pillar body opening.
  4. Align the rear LH primary seal joint line to the marking on the B-pillar.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the seal strings are positioned towards the interior of the vehicle when aligning the primary seal.
  5. Fasten the clips (x3) that attach the rear LH primary body seal to the mid C-pillar, the upper B-pillar, and the mid B-pillar.
    Informational PurposesAn informational icon, calling your attention
    Note
    For some Model 3 vehicles, there is no space to fasten the clip that attaches the rear LH primary body seal to the mid C-pillar. Cut this clip and use double-sided tape instead.
  6. Pull the seal strings from the new seal.
  7. Tuck the seal into the bright molding, and make sure that it fits properly to the trim panels and the headliner.
  8. Press the seal into the lower corners, and then install the rest of the seal to the body.
    Informational PurposesAn informational icon, calling your attention
    Note
    Stretch and tuck the seal so that it is evenly distributed around the perimeter.
  9. Install the LH B-pillar applique. See #GUID-23770827-D613-4A23-AF05-BE4B00E01701.
  10. Calibrate the windows. See Window Regulator (Recalibrate).
  11. Confirm that the window operates correctly and without any abnormal noise.