2026-05-12

Trim - A-Pillar - Upper - LH (Remove and Replace)

Correction code 15184002 0.06 NOTA: Salvo explicitamente indicado em contrário no procedimento, o código de correção acima e o FRT refletem todo o trabalho necessário para a realização deste procedimento, incluindo os procedimentos associados. Não acumule códigos de correção, salvo se explicitamente instruído. NOTA: Consulte Tempos de taxa fixa para saber mais sobre FRT e sobre a respetiva criação. NOTA: Consulte Proteção pessoal para garantir que utiliza o EPI adequado durante a realização do procedimento abaixo. NOTA: Consulte para conhecer as práticas seguras e saudáveis de trabalho.

  • 2023-07-06: Added a video in step 5 of Remove part.

Remove

  1. Open the LH front door.
  2. Remove the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
  3. Remove the LH middle A-Pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  4. Release the clips that attach the LH upper A-pillar trim to the A-pillar.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the top clip first and work forward and down.
  5. Release the LH upper A-pillar trim tether by twisting and pulling the tether hooks (x3) away from the LH upper A-pillar trim.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not remove the LH upper A-pillar trim tether from the body side. If removed from the body side, the tether will have to be replaced.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Os vídeos incluídos neste procedimento destinam-se a ser utilizados como uma visão geral apenas para efeitos complementares. Siga todos os passos enumerados no procedimento para evitar danos nos componentes e/ou ferimentos.
  6. Pull upwards to remove the LH upper A-pillar trim from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove any remaining LH upper A-pillar trim clips from the LH A-pillar, and if the LH upper A-pillar trim is to be later installed, remove all clips from the trim.

Install

  1. If reusing the same LH upper A-pillar trim, install new clips onto the trim.
  2. Make sure that the clips are undamaged, and at the correct positions on the trim.
  3. Fasten the tether hooks (x3) to the LH upper A-pillar trim.
  4. Insert the front lower edge of the trim into the instrument panel carrier, and then firmly fasten the clips that attach the LH upper A-pillar trim to the A-pillar.
    Informational PurposesAn informational icon, calling your attention
    Note
    Fasten the top clip first, and then work toward the front of the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Look through the windshield from outside of the vehicle to check that the LH upper A-pillar trim is flush with the A-pillar.
  5. Pull the primary front side body seal over the LH upper A-pillar trim.
  6. Install the LH middle A-Pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  7. Install the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).