22/03/2024 11:24:58

Remove the Meter

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Before removing the meter, ensure that all loads are switched off and all panel disconnect switches are locked out.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Even though circuits have been turned off and are not under load, service equipment may still be live. Wear all electrical PPE as defined in Required Tools.
  1. Switch off breakers for any parallel generation sources, including Powerwalls, solar inverters, and generators.
  2. Switch off all load breakers.
  3. Switch off the main service disconnect.
  4. For ring type meter sockets: Remove the meter sealing ring while wearing cut resistant gloves.
  5. For ringless meter sockets: Remove the meter socket enclosure cover.
  6. Using the meter puller, remove the meter:
    1. Slide the meter puller over the meter.
      Informational PurposesAn informational icon, calling your attention
      Note
      If the meter puller has vents, orient it so that the vents are at the top of the meter puller.
    2. Push until the clips snap over the meter’s metal band. Be careful to grip only the meter and not the edge of the enclosure.
    3. Rock up and down to loosen the blades.
      Informational PurposesAn informational icon, calling your attention
      Note
      Do not rock side to side.
    4. Pull the meter away from the base.