Cover - Battery Monitoring Board (BMB)

FRT No: 16020203

    Remove


  1. Remove warranty label between cover and enclosure.

  2. Carefully cut silicon sealant joint between rear and side edges of BMB cover to enclosure.


    3. Warning: getimagesize(../service_manual/pngthumbs/tsm0660.png): failed to open stream: No such file or directory in /Library/WebServer/Documents/TheoryOp/1.2.5/menu/svg_handler.php on line 81


  3. Note fitted position of nylon spacer, remove screws (x7) securing cover to enclosure and collect spacer (torque - 2.8 Nm / 25 in-lbs).

  4. Lift and rotate cover rearwards to release hook from channel and remove cover.
    5. CAUTION: When BMB cover is removed, DO NOT place any tools or fasteners on the enclosure.Place cover over opening when not accessing BMB or connectors. Use tape to affix if necessary.
     

    Installation


  1. Installation procedure is the reverse of removal except for the following:

  2. Remove traces of old sealant from cover and enclosure.


    3. Warning: getimagesize(../service_manual/pngthumbs/tsm0685.png): failed to open stream: No such file or directory in /Library/WebServer/Documents/TheoryOp/1.2.5/menu/svg_handler.php on line 81


  3. Ensure that all BMB retaining clips are secured before installing cover.

  4. Install, but do not tighten, the LH and RH screws first to align cover followed by the remaining bolts.

  5. Using assistance, use two plastic wedges to pull the BMB cover into place and fully tighten BMB cover screws. Tighten bolts evenly using an alternating sequence, beginning with the LH bolt. Apply pressure to top of cover near bolt while tightening to ensure bolts seat properly.

  6. Perform leak test. (Refer to procedure)


    7. Warning: getimagesize(../service_manual/pngthumbs/tsm0778.png): failed to open stream: No such file or directory in /Library/WebServer/Documents/TheoryOp/1.2.5/menu/svg_handler.php on line 81


  7. If a leak is found at the BMB cover leading edge during enclosure leak testing, carefully apply a bead of silicon sealant between rear and side edges of BMB cover and enclosure using masking tape to achieve a neat edge.

  8. Apply new warranty label between cover and enclosure. Install in same location as original label. Ensure that all label material/adhesive is removed before installing new label.

(c) 2008 TESLA MOTORS, INC.

All right reserved. This material may not be reproduced or copied, in whole or in part, without written permission of Tesla Motors, Inc.