Master Cylinder

FRT No: 33030102

    Remove


  1. Remove condenser rear exit duct (refer to procedure).

  2. Clamp brake reservoir hoses.

    3. NOTE: Place suitable absorbent material around the affected area to absorb any possible fluid spillage.


  3. Release clips (x2) securing reservoir hoses to master cylinder and disconnect hoses from master cylinder.
    4. CAUTION: Plug pipe connections to prevent ingress of moisture or dirt.
     

    CAUTION: If brake fluid is spilt on the paintwork wash off immediately with clean water.
     


  4. Release brake pipe unions (torque - 14 Nm).

  5. Remove nuts and washers (x2) securing master cylinder to servo (torque - 25 Nm).

  6. Remove master cylinder.

    Installation


  1. Installation procedure reverse of removal except for the following.

  2. Bleed brakes (refer to procedure).