05/03/2024 13:59:29

Brake Pads - Front - Set (Remove and Replace)

FRT No: 33010702

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
If the vehicle has air suspension, activate "Jack" mode on the touchscreen before raising and supporting the vehicle.

Special tool required for this procedure:

Supplier Part Number Description
Tesla 1057223-00-A Hand Brush
  • 2024-03-05: Replaced copper paste with Silaramic.

Removal

  1. Remove the front wheels (refer to procedure).
  2. Remove the pad retaining pins and collect the anti-rattle spring.
    Informational PurposesAn informational icon, calling your attention
    Note
    Always check that the anti-rattle clip has not been damaged. This part is easily damaged and is important to help eliminate squeaks.
    Figure 1. View large image.
  3. Use a suitable tool to gently push the pistons back into the caliper.
  4. Remove the brake pads from the caliper.
    Figure 2. View large image.
  5. Check that the caliper pad slides are dirt free and the seals are in good condition.
  6. Repeat steps 2-5 on the other side of the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following:
Informational PurposesAn informational icon, calling your attention
Note
Clean the affected areas before installation.
  • On both sides of the vehicle, release the caliper and thoroughly clean the caliper pad slides and abutments with a hand brush (1057223-00-A) and soapy water.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If there is rust or pitting on the caliper that cannot be removed with a hand brush, replace the caliper (refer to procedure).
    Figure 3. View large image.
  • On both sides of the vehicle, apply an even layer of Silaramic lubricant (1063021-00-A) to the caliper pad slides. Remove any excess lubricant.
  • On both sides of the vehicle, apply an even layer of Silaramic lubricant (1063021-00-A) between the shim and the backing plate. Remove any paste that squeezes out after installing the shim.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Ensure that the brake pads move freely.
  • Pump the brake pedal at least 5 times to seat the pads against the brake rotors.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Always check that the brake pads are seated correctly before driving the vehicle.
  • Top off the brake fluid level as required.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If brake fluid is spilled on a painted surface, wash off immediately with clean water.
  • Perform the brake burnishing procedure (refer to procedure).