Week Ending June 29, 2024

The following procedure(s) were updated:

1. BMS PCBA - High Voltage Battery Assembly (HV Battery 1.0/1.5) (Remove & Replace) - Added alternative sealants to replace Threebond 1216E due to non availability of Threebond in certain markets.
2. BMS PCBA - High Voltage Battery Assembly (HV Battery 2.0) (Remove & Replace) - Added alternative sealants to replace Threebond 1216E due to non availability of Threebond in certain markets
3. Contactors - HV Battery (HV Battery 1.0/1.5) (Remove and Replace) - Added alternative sealants to replace Threebond 1216E due to non availability of Threebond in certain markets.
4. Cover - Pyrotechnic Fuse - HV Battery 1.0/1.5 (Remove and Replace) - Added alternative sealants to replace Threebond 1216E due to non availability of Threebond in certain markets.
5. Electromechanical Brake Booster Assembly (Remove and Replace) - Updated installation procedure and revised references.
6. Fuse - Pyrotechnic - HV Battery 1.0/1.5 (Remove and Install) - Added alternative sealants to replace Threebond 1216E due to non-availability of Threebond in certain markets.
7. HV/LV Ancillary Unit (HV Battery 2.0) (Remove and Replace) - Added alternative sealants to replace Threebond 1216E due to non-availability of Threebond in certain markets.
8. Rapid Mate - Low Voltage - HV Battery 2.0 (Remove and Replace) - Added alternative sealants to replace Threebond 1216E due to non availability of Threebond in certain markets.
9. Vehicle HV Disablement Procedure - Added alternative part number for silicone lubricant.

Week Ending June 22, 2024

The following procedure(s) were updated:

1. Clear Forward Camera View (Precision Cleaning Of Inboard Windshield) - Updated the inspection method and diagrams and added the tool list.
2. Seal - Axle - Front Drive Unit - LH (1st Generation) (Remove and Replace) - Updated correction code to 39301202.

Week Ending June 15, 2024

The following procedure(s) were updated:

1. Fuse - Pyrotechnic - HV Battery 2.0 (Remove and Replace) - Updated parts list, deleting the fuse cover bolts and fuse mounting bolts to be ordered.

Week Ending June 8, 2024

The following new procedure(s) were added:

1. Brake Rotor - Front - LH (Measure Runout)

The following procedure(s) were updated:

1. Firmware Update - Mobile Connector - Added steps to update Mobile Connector firmware on vehicles operating software version 2024.14+.
2. Fuse - Pyrotechnic - HV Battery 2.0 (Remove and Replace) - Updated parts lists.
3. Vehicle HV Disablement Procedure - Added warning to measure the specified order of locations for high voltage.

Week Ending June 1, 2024

The following procedure(s) were updated:

1. Bolster - Side - Seat - 2nd Row - LH (Remove and Replace) - Added information on releasing the bolster from the mounting grommets. Provide upper grommet PN in case replacement is needed.
2. Contactors - HV Battery (HV Battery 1.0/1.5) (Remove and Replace) - Added parts lists.
3. Fuse - Pyrotechnic - HV Battery 1.0/1.5 (Remove and Replace) - Added parts lists.
4. Fuse - Pyrotechnic - HV Battery 2.0 (Remove and Replace) - Added parts lists.
5. HV/LV Ancillary Unit (HV Battery 2.0) (Remove and Replace) - Added parts lists.

Week Ending May 25, 2024

The following procedure(s) were updated:

1. Handle - Exterior Release - Door - Front - LH - Generation 3.0 (Retrofit) - Updated procedure to make calibration steps before software reinstall.

Week Ending May 18, 2024

The following procedure(s) were updated:

1. Clear Forward Camera View (Precision Cleaning Of Inboard Windshield) - Updated the procedure title.

Week Ending April 27, 2024

The following procedure(s) were updated:

1. Actuator - Pedestrian Protection - LH - 2nd Generation (Remove and Replace) -
2. Module - Passive Safety Restraint - PSRCM (Remove and Replace) - Updated Toolbox routines to be run after replacing the PSRCM.

Week Ending April 20, 2024

The following procedure(s) were updated:

1. Power Conversion System Coolant (Drain) (On Table) - Added list of required equipment.

Week Ending April 13, 2024

The following procedure(s) were updated:

1. Handle - Exterior Release - Door - Front - LH - Generation 2.1 (Retrofit) - Procedure updated to latest validation.
2. Clear Forward Camera View (Precision Cleaning Of Inboard Windshield) - Added detailed instructions on how to clean the windshield and added steps of camera inspection after cleaning.
3. Windshield (Remove and Install) - Added a step of cleaning the windshield, especially the forward-facing camera area, to ensure a clear view of the forward-facing camera.

Week Ending April 6, 2024

The following procedure(s) were updated:

1. Fluids - Added new Gearbox Fluid section. - Updated washer fluid for North America.
2. Four Wheel Alignment Check and Adjust (Air Suspension) - Added step to cycle TAS air suspension height.
3. Headlights (Adjust), Europe (ECE) - Updated measurements and units.
4. Headlights (Adjust), North America (SAE) - Updated measurements and units.
5. HID Bulb – Headlight - LH (Remove and Replace) - Added steps to remove and install bulb lock collar.
6. Receiver Dryer and Desiccant (Remove and Replace) - Added reminding of checking the pressure of A/C system before opening the accumulator.