Week Ending September 28, 2024

The following procedure(s) were updated:

1. Steering Yoke/Wheel (Remove and Replace) - Added a note about mechanical horn retrofit.
2. Touch Horn Steering Yoke/Wheel To Mechanical Horn Steering Yoke/Wheel (Retrofit) - Added information for round steering wheel configuration settings.

Week Ending September 21, 2024

The following procedure(s) were updated:

1. How To Use This Manual - Added information on the crowsfoot/offset wrench extension calculator.
2. Skidplate - Front (Remove and Replace) - Added new fasteners PN and torque value.

Week Ending September 14, 2024

The following procedure(s) were updated:

1. Car Computer (Remove and Replace) - Added owner authorization request and LV maintainer steps.
2. TPMS (Sensor ID Tool Learn) - Added note with links to update TPMS Tool firmware.

Week Ending September 7, 2024

The following procedure(s) were updated:

1. Seat Cushion - Lower - 2nd Row (Remove and Replace) - Added note to perform ISOFIX flap retrofit for older vehicles.
2. Desiccant (Remove and Replace) - Added warnings to wear suitable protective clothing, consisting of face and eye protection, heat-proof gloves, rubber boots and apron or waterproof overalls must be worn when carrying out operations on the air conditioning system.

Week Ending August 31, 2024

The following new procedure(s) were added:

1. Wheel Disposal (Rework)

The following procedure(s) were updated:

1. Clear Forward Camera View (Precision Cleaning Of Inboard Windshield) - Added a step to clean the wiper blades.
2. Tesla Badge - Rear (Remove and Replace) - Added a note to remind that the rear badge is not reusable due to the positioning problem.
3. Wheel - Front - LH (Remove and Replace) - Added instruction on wheel disposal.

Week Ending August 24, 2024

The following new procedure(s) were added:

1. Car Computer (Remove and Replace) - Car Computer replacement procedure that uses Toolbox to associate the replacement computer. Please send us feedback on this procedure!

Week Ending August 17, 2024

The following new procedure(s) were added:

1. LV Battery - Recover - Please send us feedback on this procedure!
2. OBD Connector (Retrofit)
3. Trim - Bolster - Inner - Seat - 2nd Row - LH (Remove and Replace)

The following procedure(s) were updated:

1. Battery - LV (Remove and Replace) - Added step to maneuver LV battery for clearance to remove HEPA filter cover.

Week Ending August 10, 2024

The following procedure(s) were updated:

1. Subframe Assembly - Rear (Plaid) (Remove and Install) - Updated tool info and image.
2. Subframe Assembly - Rear (Remove and Install) - Updated tool info and image.

Week Ending July 27, 2024

The following procedure(s) were updated:

1. Fuse Locations - Update the link of Electrical Information.
2. Toolbox 3 (Connect and Disconnect) - Added instructions and warning for OBD-II to RJ45 Ethernet diagnostic equipment.

Week Ending July 13, 2024

The following procedure(s) were updated:

1. Decor - Instrument Panel - Main (Remove and Replace) - Added steps for removal and installation of the IP closeout panel.
2. Subframe Assembly - Rear (Plaid) (Remove and Install) - Updated torque figure for the bolt that attaches the active damper to the rear knuckle from 150 Nm to 140 Nm.
3. Torque Specifications - Suspension - Updated torque figure for the bolt that attaches the active damper to the rear knuckle from 150 Nm to 140 Nm.

Week Ending July 6, 2024

The following procedure(s) were updated:

1. Clear Forward Camera View (Precision Cleaning Of Inboard Windshield) - Updated tool part numbers.