25/06/2024 01:09:05

Link - Fore - Upper - Rear - RH (Remove and Replace)

Correction code 310315022.4NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
For Europe only: Only technicians who have been trained in working with diisocyanates and have completed all required certification courses are permitted to perform procedures using urethane and other products containing diisocyanates. Proper personal protective equipment (PPE) must be worn when working with products containing diisocyanates.

Remove

  1. Remove the front subframe assembly. See Subframe Assembly - Front (RWD) (Remove and Install).
  2. Remove the bolt and nut that attach the RH rear upper fore link to the knuckle.
    76 Nm (56.0 lbs-ft)
  3. Remove the bolt and nut that attach the RH rear upper fore link to the subframe.
    76 Nm (56.0 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Turn the bolt a few times to feed the end out while maneuvering the upper fore link to allow just enough space to remove the link from the rear subframe.
  4. Remove the RH rear upper fore link from the vehicle.

Install

  1. Install the bolt and nut that attach the RH rear upper fore link to the subframe.
    76 Nm (56.0 lbs-ft)
  2. Install the bolt and nut that attach the RH rear upper fore link to the knuckle.
    76 Nm (56.0 lbs-ft)
  3. Install the front subframe assembly. See Subframe Assembly - Front (RWD) (Remove and Install).
  4. Refer to the Alignment Requirement tables to determine whether an EPAS alignment check (EC) or four wheel alignment check (AC) is necessary. If performed, add the alignment check/adjust as a separate activity. See Alignment Requirement - Suspension.