25/04/2023 20:37:10
Airbag - Side - Driver (Remove and Replace)
Correction code
20010702
0.60
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Warning
Make sure 12V/LV power has been disconnected for at least 1 minute before disconnecting the electrical harness from Supplementary Restraint System (SRS) components, such as Restraint Control Module, sensors, airbags, etc. Failure to do so can result in unintended safety system behaviors. For more information on SRS precautions, see Airbag and Supplementary Restraint System (SRS) Precautions.
Note
When the airbag has desployed, replace the 1st seat
assembly. See Seat Assembly - 1st Row - LH (Remove and Replace). If the airbag does not
deploy, continue to use this procedure to replace the airbag.
- 2023-04-26: Add a note to clarify when to replace the airbag and when to replace the 1st row seat assembly.
Remove
- Remove the driver seat backrest foam. See Foam - Backrest - Driver Seat (Remove and Replace).
-
Pull the seat back cover
away from the foam assembly, and then remove the side airbag from the
seat.
Install
Installation procedure is the reverse of removal.