07/03/2024 10:18:47

Switch - Tonneau (Remove and Install)

Correction code 1220310001 1220310002 FRT 0.05 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-03-07: Added the adhesive tape to the installation steps.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the tailgate.
  2. Open the tonneau cover.
  3. Partially release the rear edge of the LH sail applique by firmly pulling upwards, and then release the harness clip and disconnect the tonneau switch electrical connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure to peel the rearmost strip of two sided tape only.
  4. Release the retaining tabs (x4) that attach the tonneau switch to the LH sail applique, and then push the switch upwards to remove it from the applique.

Install

  1. Replace the two sided adhesive tape on the LH sail applique:
    1. Remove the existing strip of the two sided adhesive tape. Clean off any residue with IPA wipes and a non-marring scraper. Allow IPA to dry for 1 minute.
    2. Cut a 75 mm strip of two sided adhesive tape (2057307-00-A), and then peel the backing from one side and apply to the sail applique.
  2. Replace any sail applique clips on LH sail applique that have been removed.
  3. Position the tonneau switch to the LH sail applique, and then press the switch downward into the applique until the retaining tabs (x4) engage.
  4. Connect the tonneau switch electrical connector and secure the harness clip.
  5. Peel the adhesive backing, and then secure the rear section of LH sail applique.
  6. Close the tailgate.
  7. Close the tonneau cover.