03/09/2024 15:13:14

Steering Column and Wheel - Steering Wheel Switch - LH (Remove and Replace)

Correction code 3205111082 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-09-03: Removed front rack calibration UI steps.
  • 2024-06-11: Added steps to perform front steering rack calibration.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the steering wheel upper shroud. See Steering Column and Wheel - Shroud Upper - Steering Wheel.
  2. Remove the bolts (x4) that attach the LH steering wheel switch to the steering wheel, slowly pry the switch from the bezel, and then disconnect the electrical connector.
    1.5 Nm (1.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Move the connector to access bolt if needed.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull the switch from the inner portion of the steering wheel to not separate the button from the base.
    Tip: Use of the following tool(s) is recommended:
    • Torx T10 bit

Install

  1. Position the LH steering wheel switch to the steering wheel, connect the electrical connector, and then install the bolts (x4).
    1.5 Nm (1.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the bezel and switch are flush.
    Tip: Use of the following tool(s) is recommended:
    • Torx T10 bit
  2. Install the steering wheel upper shroud. See Steering Column and Wheel - Shroud Upper - Steering Wheel.
  3. Place the vehicle into Service Mode. See Service Mode.
  4. On the vehicle touchscreen, navigate to Service Mode > Software Reinstall, tap REQUEST, and allow the routine to complete.
  5. Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect).
  6. Perform Handwheel calibration. See Set Handwheel Zero.
  7. Disconnect Toolbox and remove the laptop from the vehicle. See Toolbox 3 (Connect and Disconnect).
  8. Exit Service Mode. See Service Mode.
  9. Raise the LH front window and close the LH front door.