2024-10-30

Windshield Washer Bottle and Pump - Windshield Wiper Washer Hose (Remove and Install)

Correction code NEW NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the frunk assembly. See Frunk Assembly (Remove and Install).
  2. Release the windshield wiper washer hose from the washer tank tabs (x3).
  3. Release the clips (x2) that attach the windshield wiper washer hose to the vehicle, and then remove the hose from the vehicle.

Install

  1. Position the windshield wiper washer hose into the vehicle, and then secure the clips (x2) that attach the hose to the vehicle.
  2. Secure the windshield wiper washer hose into the washer tank tabs (x3).
  3. Install the frunk assembly. See Frunk Assembly (Remove and Install).